Messages

Ok thank you for the help !

The rest of the circuit... but the polarity I shown was right or not ?

So to be sure, that would make : Input .... [(-)Caps(+)]..... the nut

Yep pretty sure, I bought it there : http://www.banzaimusic.com/0-1uF-50V-Radial.html

Hum, higher voltage ok but on the schematic the capacitor is between the input and a nut...
http://www.madbeanpedals.com/projects/Slambox/docs/Slambox_ver.4.pdf

Ok thank you for you're help

I'll post picture once it's done !

So that means that I can put the capacitor in any polarity ?
The value requested on the schematic is 100nF and I use 0.1uF... I think that's the same

Hi,

I was wondering if i can use a polarized Cap instead of a non polarized one in the Slambox ?
If yes, in which sens ? Does the polarity still matters or not ?
When I bought my coponents I didn't pay attention to the non-polarity of the C1 (100nF)...

I know that's not a big question but i didn't find any thing about it and I'm in somewhat a very big noob in electronics, the Slambox is my first build.

Thank you.