Messages

Can someone tell me where the led/ground goes on lug1 and lug2?

Hi,
I'm trying to build a 2 overdrives in 1 enclosure and was wondering if anyone could help me out with a pedal order switcher....like the ones JHS uses in their dual pedals.

I want to have a toggle switch that can change the order of OD1 -> OD2 or OD2 -> OD1. 

If you have any visuals or diagrams that would be greeeeatly appreciated.  Thanks!

I don't recall exactly, but I'm pretty sure I tested it with the gain turned up to max with no LED flickering. 

I'm seeing something new that I didn't see before.  There's a pad that has nothing in it (not labeled in egodriver diagram) but I think it connects the R6 resistor to the LED clip pads.  Could this be the culprit for the led clipping not working?

Yes, I believe so.

The positive leg goes to square pad on D3 and neg leg goes to circle pad on D4.  Pretty sure the wiring is correct for on/off led.

Sweet.  So I'm guessing this circuit would just go before the cupcake circuit?

Thanks for sharing.

hi, complete noob here. 

I'm having a few issues with my new egodriver build.

1. LED doesn't light up
2. LED clipping doesn't work - LEDs don't work either

The pedal itself works (minus the led clipping).

Any thoughts?

Is it possible to add a clean blend knob using the current cupcake pcb?