Messages

any suggestions please... 

Ok! I wont crank it all the way up anyway so thats cool..

But do you know what might cause the behaviour of the clip switch?

THX!

Have the same issue with the stuttering sound at full gain. Besides that the pedal sounds great..

But i also noticed that there is no difference in sound between middle position and left position of the clip switch..
Any idea what's causing that?

THX!

Hi!

So i fired it up and it sounds great! There's only one problem i encountered... When i have the Clip Switch in the middle position and the OD Switch on the right the sound starts to stutter, like a tremolo..
for D2 and D3 i used a 1n914 and D8 and D9 a red LED..

Do you know what may be wrong?

THX!

Great thanks!

Does this have any major influence on the sound?
By the way, im using two red LEDs for D8 and D9, does it matter which way around i put them in?

THX!

Hi!

I have no 1uf poly film type caps for C5, C11 and C16. Can i use electrolytic instead?

THX!

ok! now i get it! 

so.. i just use a standard true bypass wiring now..

THX!

just to be perfectly clear before i fire this thing up...
the wiring shown on page 5's layout is for true bypass?   

Thanks!!

im using true bypass now.. made the changes and removed the parts listed..
just dont know where to put the rtb now...

Thanks!

But where do i have to put the RTB? On Page 5's Layout there seems to be no place for it..

I have built the Sunking acording to this: https://dl.dropbox.com/u/1320332/Sunking_ver.3-1.pdf

I'm a bit confused because the layout on page 1 is quite different than the one on page 5, and so is the wiring.
I would like to build the buffered version from page 1, but i have the PCB from page 5 and there are no pads for the Switch like on the page 1 layout.

Any advice?
THX!

Hi!

I wanted to ask where i can fin the Pork Barrel PCB Layout to print it out.

THX!

Hello!

I wanted to ask if its possible to use the Krankosaurus PCB without the Boost. And what i have to do to make that work.

Thanks!