Messages

There's a bunch of little changes--I had a quick look and the most complicated part would be incorporating the dual gang body pot

here's the schems (top one is easier to read)

Thanks for posting this. You guys think it's worth doing? How hard would it be to incorporate the dual pot?

Anyone know if it's possible to modify/change components to convert a Green Bean PCB into a LGW circuit? My Cosmo board that was converted to LM specs sounds KILLER. Just curious to see if it's possible

Cheers

Yes, there will definitely be a reverb project. I can't say when exactly, but my plan is to have it be a bit different than some of the other ones that are currently out there....I've sketched out the basic idea already.

Will it be using the Belton module? Just curious! An added footswitch to switch between two settings would be pretty killer I think

I'm going to build this pedal, too. I bought BC108, BC109 and 2n5088s. I'll try them and tell you how it goes. But I agree that the BCs would be a good choice, because I heard them on youtube in other DIY One-Knob-Fuzzes, and I really liked them...

Yeah for sure let me know! Sweet, looks like I'll start with BC109's then!

Any suggestions?

I'm getting ready to start this build and I'm curious which ones would be the best choice..

Cheers!

You know, I just went & looked.  Actually smallbear does have 2kb pots so there you go.

Oh okay, can't beat that!

smallbear or mammoth.  pc mount pots should probably be available in all those values except the 2k.  for that one you can just use a 5kb pot with a 3.3k ohm resistor soldered between lugs 1 & 3 and that should get you in the neighborhood.

B at the end of the pot value means linear
A means audio or log

Thanks a million for that! I didn't even think about using a resistor. Will that have any affect on the sound?

I'm having trouble finding the pots for a cosmo build

Any one have any ides as to where I could find some?

Cheers!