Messages

i dunno...

but, i have two fuzz factories.
one from zvex and one that i built.

and i find that the one i built sounds thinner and harsher than the store bought one.
i think it might be the germs causing the anomaly though

hm i guess i'll just stick with buying delays other people make then

i was just wondering?
what makes building a delay more difficult than overdrives and fuzzes?

haha yea i figured i had no choice so i started doing that already
but i have no more time, so i'm just gonna have to finish debugging when this semester ends

thank you for all the help

o yea. basically, the other pot and 3pdt switch is for a SHO circuit
because i wanted a boost before the ocd. the SHO works fine, i just dunno why the ocd doesn't

I'm using a TL082CN op amp, and the readings are

1,2,3,5,6,7 = ~4.57V
4 = 0.04mV
8 = 9.14V

i'm using 2n7000's too

thanks for all the help btw. truly appreciate it

i have 1nF (102) for C4, and 100 nF (104) for C11

ok so basically i'm not getting any overdrive.

vol control works, tone control works. but even when the gain is all the way up, there is no overdrive
here's my pcb



there's that one cap that's sticking out, but i think it's not what's wrong