sorry for the gargantuan delay, ive been extra busy the last couple weeks. Here are pics of the board.
- Welcome to madbeanpedals::forum.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
Tech Help - Projects Page / Help with first build (Florist)
May 06, 2023, 11:22:00 PM
I just finished all the wiring for my florist and tested it out. Clean audio comes through when its off but as soon as I turn it on it feeds back unless the volume pot is basically at 0. All three of the top pots do nothing and all three of the bottom pots seem to just increase feedback.
I checked all the voltages and everything is correct except for the PT2399 is getting
PIN
5 - ~16v
6 - ~2.8v
7 - ~.59v
8 - ~.61v
Idk what I'm doing, please help. BTW I am pretty good at soldering and was extremely careful about using all the correct values.
I checked all the voltages and everything is correct except for the PT2399 is getting
PIN
5 - ~16v
6 - ~2.8v
7 - ~.59v
8 - ~.61v
Idk what I'm doing, please help. BTW I am pretty good at soldering and was extremely careful about using all the correct values.
Pages1