Thanks Mauman - what's the reason the resistor has to be between pin 2 and the 10uF cap?
- Welcome to madbeanpedals::forum.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
How Do I? Beginner's Paradise. / Adding a tone switch
August 01, 2022, 12:29:53 PM
Hello All,
I am looking to build a red llama clone and I am repurposing an enclosure which has two holes drilled for pots and one for a mini toggle switch.The Red Llama doesn't have a tone switch and I don't want to have a disconnected toggle filling the hole so my question is;
Would an on-off-on SPDT switch with two caps (for instance in the range of 5-47nF) going to ground work as a tone switch? If so, where on the board would I connect it? Would it just be at the output? And if not, what are my options so I have a functional toggle switch on my pedal?
I am looking to build a red llama clone and I am repurposing an enclosure which has two holes drilled for pots and one for a mini toggle switch.The Red Llama doesn't have a tone switch and I don't want to have a disconnected toggle filling the hole so my question is;
Would an on-off-on SPDT switch with two caps (for instance in the range of 5-47nF) going to ground work as a tone switch? If so, where on the board would I connect it? Would it just be at the output? And if not, what are my options so I have a functional toggle switch on my pedal?
Pages1