Messages

Just to be absolutely sure: by saying "the upper row" you mean when looking from the shaft side? 

Thanks you!

Hello. I'm planning to build the Standout based on the material provided on the VFE homepage (board layout, schematic etc.)
I kindly ask if anyone can answer my remaining questions:

1. I bought dual C100k pots. I'm planning to solder a 10k resistor in parallel to one of the tapers, so there will be a 100k and a 10k resistance. Is this going to work or do I need to replace the wafers?
2. At the schematic the pots aren't labelled, so I'm not sure which "level" of the pots has to have 100k (the contacts closer OR further away from the pot)?

I hope my questions can be understood, English isn't my mother's tongue ;-)

Thank you!