Messages

Another endorsement for the Meatbox from me.
A fantastic pedal for bass, now almost mythical status - could see it being very popular.

Cheers
Nick

Just finished my Pork Barrel. What a beautiful chorus, easy build too - thanks Madbean.

Using mine also mostly on bass too, a fretless. I'm finding not quite enough low end (for me) when 'wet' switch is engaged. Gonna try experimenting with some values of C25 & C17 this weekend.

Cheers
Nick

Not that its necessary, but you can solder capacitors in parallel to combine the values. So 6.8nf in parallel with a 1.5 nf would be 8.3nf which would be as close as you could get. Just a hint for later when you DIY.  

Thanks for the advice mate. I've actually done that before with caps & resistors to get the right value (if critical), but the board  is pretty crammed as it is, with quite a high part count - there's just enough room to get the smallest of caps in there anyway!  

Many thanks Stecykmi, much appreciated.
10nF it is then! 

Hi All,
Just at the end of build for my Pork Barrel chorus, but having trouble sourcing the 8.2nF caps (C10 & C15). Could somebody please advise on possible subs for these caps, if values not critical?
I've got some 10nF & some 6.8nF caps in my components box, was wondering if these would do the job(?)

Any advice would be greatly appreciated.

Many thanks
Nick

Looking forward to release of a phaser. Need a good one for bass! 

I'm going to jump on the back of this thread, rather than starting a new one, just to say hello & thanks (Madbean) for a great site.
I'm a bassplayer, been building pedals on & off for about twenty years now.
Finished off a Faultline, nice PCB BTW, bassplayer friend likes it so much he's got it!
Gotta make another! 

Cheers
Nick