Messages

Nice job, how did you set the bias please?
Maybe a sound clip?

Hello everyone and happy new year, does anyone knows the difference between this circuit and the Blue driver. I have read it's pretty close but i don't know where is the differences.
Thank for your answer.

Hello, does anyone know the difference with the BK Butler Tube Driver and the Blue Tube. Do you think the Archibald project can tweaking to the Blue Tube version?
Thank and have a good new year's eve.

R30/C20 form a low pass filter @1.6KHz.

If you want more gain, just reduce R31.

Ok thus if i want less gain i have to increase R31.
I have think about an other thing:
1)The Switch just connect the ringer section to ground or not. If i put a pot in place of this switch normally it wil work ?
2)The R32 can be replace by a pot as a volume control of the output of Ic1a
I wil test with the R31 resistor.
A pot

Hello everyone, i build a octave divider based on the byoc pcb, work great.
Now i'm looking to make some adjustment. When i switch the ringer "On" the volume just really drop.
If i want to control the ringer volume do you think if i add a pot between:
C20 and R31 it's will work?
In fact i don't understand after R30 what C20 and R31 do in this cricuit.
Before it's a green ringer schematic i'm ok with that but after...
Thank you.
Schematic (look around IC1A):
http://byocelectronics.com/dividedoctaveschematic.pdf

Oh yes very cool, finally i've got i'm looking for with addition an other resistor in parallel to get something around 150r. That's work good. In fact i was wonderig a recovery volume bettween on/of switches.
I Will explore your purpose.
Thank

Hello, i'm  looking to get more output volume on the naughty  fish project. At the schematic i see R11 are for 560r, if down this value around 150r, does it make other change except  the volume output.
When i use the naughty fish with bass 1M pot on the gain and use it around 10H to have less high frequency reponse on the wah effect (To maintain the low) the output volume are to low.
When i go with 500K gain pot, i can't dial with the low frequency i'm looking in the sound with a bass. With guitar and other it's perfect because i go around 12H or more.
Thank for reply.