Messages

I'm glad I wasn't the only one having trouble locating the part.  I build lots of pedals, but usually manage to source replacements.  This one had me stumped so I really appreciate the help of everyone who came to the rescue!

I'm on a Lovetone binge so I'm working on a Meatball now.  I'm planning the Flange-A-Rama next because I could not find a board for a Lovetone ? Flange. Did you etch your own?

Thanks so much for the lead.  While sourcing the TL750, I also found some of the NJM2930 at UT Source and they were quite a bit less expensive so I ordered some of each.  https://www.utsource.net/sch/NJM2930L08

BTW, to round up the order for freight requirements, I ordered a few MN3007 there. Probably recycled pulls, but they arrived in good condition and are working well.

Got it!  Thanks so much for your help.  I'll try to get my hands on some TL750's or use a 12v power supply.

Thanks for your quick response.  Since it's just an 8 volt regulator, is an L78L08 worth a try since I have some on hand?  Thanks!

Hi there, thanks for the post. Nice work.  I'm starting on one of these and this gives me a good idea of what I'm in for!

Going through the parts list, I have not been able to locate any info on REG1 - JMC2930L08.  On your build, it looks like you used a TO-92 type regulator, but the only part I find that is close is an LM2930T-8.0, which has a TO-220-3 package. I'll really appreciate if you can point me in the right direction.  Thanks!