Great job.
- Welcome to madbeanpedals::forum.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
Build Reports / Re: Latest Build using a Chunk Chunk board
September 20, 2010, 11:14:07 PM
Got the knobs in today.
#3
Build Reports / Re: Latest Build using a Chunk Chunk board
September 18, 2010, 09:36:33 PM
Sure can.
#4
Build Reports / Re: Latest Build using a Chunk Chunk board
September 17, 2010, 12:44:57 AM
I used a 1N4007 and it worked just fine.
#5
Build Reports / Re: Latest Build using a Chunk Chunk board
September 16, 2010, 10:09:33 PM
Make sure you have good solder joints. Make sure you don't any caps or resistors mixed up on the board. It is easy to get mixed up while putting this one together.
#6
Build Reports / Re: Latest Build using a Chunk Chunk board
September 15, 2010, 04:02:30 PM
Whats it doing? I followed the destructions and then tweaked by ear.
#7
Build Reports / Re: Latest Build using a Chunk Chunk board
September 15, 2010, 02:51:24 AM
My son likes the cartoon Invader Zim. Zim is the one on the pedal.
#8
Build Reports / Re: Latest Build using a Chunk Chunk board
September 15, 2010, 02:47:56 AM
Thanks guys.
#9
Build Reports / Re: Latest Build using a Chunk Chunk board
September 14, 2010, 10:19:02 PM
I ordered 1/2" green knobs for it.
Pages1