R13 and R14 has the correct values and pin 10 and 11 are distorted. Gonna order another chip. Thanks for the help! I bought it from a Swedish dealer btw, moodysounds. No idea where they get them.
- Welcome to madbeanpedals::forum.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#1
Tech Help - Projects Page / Re: Aquaboy distortion problem, probably ne570
October 29, 2017, 12:47:41 PM #2
Tech Help - Projects Page / Aquaboy distortion problem, probably ne570
October 28, 2017, 04:51:33 PM
Hi! I just finished an aquaboy. I get signal but the delays are extremely distorted. I think it behaves as intended otherwise, but it's hard to hear for all the noise. Audioprobing I think I've located where the distortion happens. Pin6 on the ne570 has a clean signal, close to the original, and pin7 is very distorted and very loud. At pin5 I get a quiet and slightly distorted signal.
All voltages are fine except pin1 which starts at around .300V, then climbes to around .400, before it starts over. And pin16 that is at around 1.8V.
All voltages are fine except pin1 which starts at around .300V, then climbes to around .400, before it starts over. And pin16 that is at around 1.8V.
Pages1