Messages

Thankyou bsoncini i wasn't sure what the L pad is.
I took these voltage readings:
-9  >  led +      = -8.98
-9  >  t3,1              =-3.4
-9  >  d1 anode           = -9.21

Bio might just be the colour scheme i used with the wires lol.

I've tested with my DMM and 9v is going into the board.. The LED isn't powering up and the pedal itself doesnt actually work. I thought my solders were pretty good.

Any advice or tips to troubleshoot?

I attached a picture.

Hey bsoncini,

Relatively new to this stuff so sorry if i'm not knowing everything you said. The PCB i just bought is the Madbean Tonebender (silicon). The thing i find most complicated about these pedals are the solder parts pictured.

Where can i find the guides? By guides i mean like other peoples step by step diary kind of thing.

I'm new to effects pedals. I have built a simple microphone pre-amp (JLM Mono with great success) and had some success with a WSG by MFOS. They were both kits.

I bought the Stank PCB awhile back but messed up pretty hard. This time around i was hoping to complete the Tonebender with no mistakes so i bought 2. And i was hoping someone might have a guide.

Roaraudio