Thanks! That's great.
- Welcome to madbeanpedals::forum.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#1
Open Discussion / Re: Laser engraving enclosures with a cheap Chinese machine? Yes!
July 24, 2017, 12:31:36 PM #2
Open Discussion / Re: Laser engraving enclosures with a cheap Chinese machine? Yes!
July 23, 2017, 09:30:54 PM
I don't have the machine, that's why I'm asking. Which is the size of the beam? I've been watching demos on you tube and seemed that those small boxy NEJE low powered lasers were etching (I don't remember seeing any of them cutting) crispier lines than the 2.5W, but I might have had the wrong impression from the videos. Thanks!
#3
Open Discussion / Re: Laser engraving enclosures with a cheap Chinese machine? Yes!
July 23, 2017, 12:58:15 PM
Is it possible to have thin 0.5mm super sharp, clean cuts with a 2.5W cheap Chinese machine (let's say on paper, at least) without any burning marked outlines? Thanks!
Pages1