Messages

Thx @sominf!!
I will check the audio probe tomorrow or the next days and write you back!
The break was also good to come down!
Have a nice working day!
See ya & thx so much again!


Also Thx @ ShredderNemo!
I checked the transistors with some guy @ my university... He thinks they should be ok!
Mhmn...damn. Do you have some other ideas?

Greetz

unfortunately no sound :/

What bout the measured data, are they correct?

Or can I do something else?

Alright, I put something between

Hey guys

- On the board there is 9V from Gnd to V+
- The Power Test at Page 4 of the construction guide matches also.
- On the Attachment you can see the IC's and transistor test results on a sketch & also the solder side of the board

Thx you so much!

Thx for your fast reply

And sorry for my vague infos, I am new here..

I finished the setup.... wired it up and no tone came out...
After that I checked all my soldering digits and also checked the wiring stuff 3 times.
In the attachement you can see the pix of the flanger!

Thx so much 4 your support

Hey guys,

I bought the Flangelicious from DasMusikding & after wiring the components together there came no tone out of it...

Do you have any suggestion where & what I can debug to find the mistake?

I followed the following setup instructions:

- the construction guide from: http://electricdruid.net/wp-content/uploads/2016/05/FlangeliciousConstructionGuide.pdf
- and the project page: http://electricdruid.net/flangelicious-a-super-dooper-flanger/

Thanx for your support

Cheers

Ben