I guess it would be helpful to add the schematic. I am trying to split the 4 dip switches into two toggles. Is what I am looking for possible or will I just have to do four switches?
- Welcome to madbeanpedals::forum.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#1
How Do I? Beginner's Paradise. / Re: Sanity Check! Diode Switching on Mudbunny and QOB
July 14, 2017, 05:42:42 PM #2
How Do I? Beginner's Paradise. / Sanity Check! Diode Switching on Mudbunny and QOB
July 13, 2017, 09:11:10 PM
So I am working out replacing the dip switches on my Queen of Bone with a toggle switch. Can someone verify my wiring is correct with a on-off-on SPDT toggle?
Secondary question. If I set up a diode switch with a DPDT toggle on my mudbunny and connect it to D1, do I need to jumper the other diode pads?
Thanks!
Secondary question. If I set up a diode switch with a DPDT toggle on my mudbunny and connect it to D1, do I need to jumper the other diode pads?
Thanks!
Pages1