Somebody else already offered. I'll get back to you if I need more in the future..
Thanks
Mike
Thanks
Mike
- Welcome to madbeanpedals::forum.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#1
Open Discussion / Re: Is it bad etiquette to ask for a one-off PCB around here?
April 15, 2017, 10:46:56 PM #2
Open Discussion / Is it bad etiquette to ask for a one-off PCB around here?
April 14, 2017, 03:54:31 PM
I haven't been around the madbean forum in many years, so let me know if I'm breaking any rules/culture here
I'm planning to make an Echo-matic, but I think this PCB is starting to get a little too complex for me to fake it with perfboard. I don't really have a setup to make PCBs (and kind of don't want to get into that hobby), so I was hoping someone with an etching setup might be able to help me out. I'll obviously pay you for your time/materials. The PCB transfer is at the bottom of this page:
Here is a cleaner image (for 600 dpi), it may need to be reversed depending on your transfer method:
I'm planning to make an Echo-matic, but I think this PCB is starting to get a little too complex for me to fake it with perfboard. I don't really have a setup to make PCBs (and kind of don't want to get into that hobby), so I was hoping someone with an etching setup might be able to help me out. I'll obviously pay you for your time/materials. The PCB transfer is at the bottom of this page:
Here is a cleaner image (for 600 dpi), it may need to be reversed depending on your transfer method:
Pages1