Messages

I just got my BBRR and completely forgot to order the slide switch for use with different charge pumps. I ended up getting the LT1054 for its higher current capabilities and don't really plan on swapping it out for a different charge pump.

Outside of the *need* to switch were the LT1054 or other compatible configured charge pump to become unavailable, if my plan is to stick with the LT1054, I'm assuming the slide switch becomes unnecessary and the spot on the board can be left unpopulated. There is no need to jumper the switch spot, right?

What you want to do is use the two pads for C22 as the send and return (IOW, omit C22 from the Moodring). Round pad of C22 goes to - of new 1uF, + of same 1uF goes to input of inserted effect. Output of inserted effect to - of another 1uF cap and + of same cap goes back to the square pad of C22 on the MR PCB.

Awesome! Thank you so much! I figured it wasn't too difficult to do, but I hadn't seen any documentation describing what to do. I'll be sure to post up my work once I finish!

I tried looking for any thread regarding this subject, so if I missed it I'm sorry.

With that out of the way, I just ordered the Moodring reverb with the idea of adding another circuit to only the reverb tails. My question is, is it just as simple as figuring out the best place to split off the signal to run it through the second effect, or are there other considerations? In looking at the circuit, my best guess would be right after the reverb tone control and before the gain recovery stage (In red) or between the output of the BTDR and the tone control (seen in green).

Any insight or direction to posts relevant to this would be appreciated!