Messages

Okay thanks!

Hi everyone,

Just a quick question about which resistors are the CLRs for the on/off LED and the rate LED. From what I am seeing in the PDF, I would guess R37 for the on/off and R36 for the rate as they are the only ones connecting to the LEDs. Can I change the value of these resistors without it changing the sound of the pedal?

Thanks,

Mart

thanks again m-Kresol!

thanks for that m-Kresol, much appreciated. 

are there exceptions like film caps with 2.5mm spacing?

Is there a standard that is used for capacitor lead spacing on Madbean projects?

Hi everyone,

I am looking into the Total Recall build and I need someone to verify if
I understand the BBD requirements correctly:

Total Recall: 2x MN3005s

Total Recall + TRXPN: 4x MN3008s

Or is it possible to combine the MN3005s and the MN3008s...

Cheers,

Mart

Hi everyone,

I am considering a Total Recall build and I was wondering if my Pedal Power 2 Plus would power it. Below the description from Voodoo Labs for the Pedal Power 2 Plus.

Thanks,

Mart

Pedal Power® 2 Plus Features

18V/24V – Using Custom Cables
All of the outputs on the Pedal Power 2 Plus (and the original Pedal Power) are completely isolated allowing you to create different voltages. You can run effects like the current MXR Flanger by combining two 9V outputs to create a single 18V supply. By switching two outputs into 12V ACA mode, you can join them together to create a 24V output for powering numerous Electro-Harmonix stompboxes including the Deluxe Memory Man.