News:

Forum may be experiencing issues.

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - dootmeng

#1
Tech Help - Etcher's Paradise / Touchstone Question
July 12, 2017, 12:47:07 AM
Hello all,

I'm currently in the process of building (verifying also I guess?) the Touchstone build. All is going well so far, however I have a point of clarification with regards to C17 (bottom LHS of schematic). C17 is supposed to be a bipolar electrolytic capacitor correct? Also, could I potentially substitute a  2.2 uf monolithic capacitor?

Also, with the 2.7 nf capacitor C10 (middle-ish RHS of schematic), would I be able to get away with using a 2.2 nf or perhaps a 3 nf capacitor.

I've attached the schematic below. Thanks all!