Messages

I'm getting -23.7vdc and moreover it works great

It works great

Awesome, thanks Brian

Hey guys, I just ordered a EHX 24Vdc from Amazon for my Total Recall build.  Before adding power to the pedal, I measured the output of the power supply and I was reading 32.3Vdc.  Can I use it safely?  Any help would be appreciated.

Thanks

Got it working wrong resistors. I mistakenly used 510 ohms instead of 510K.

Let me clarify, It's almost no volume, you can barely hear it.  Like a broken speaker.

Anyone here has had a problem with the volume being to low on a Stratus Aion build?

OK got it working Q11 and Q12 (MPSA13) replaced.  The way I figured it out was by shorting the ground on Q11.  Hope that helps someone else.

So I finished My Harbinger 1.5 today when I powered it up 9V the bulb pulsated for about 3 seconds and the light remained steady.  so I disconnected the power and tried it again, and same thing pulsates then stops.
Any help

Do you know what I can do to mod the NomNom so the effect to start early ?

Thanks, I screwed I had the Diodes swapped.  All good now, but I used a 20k trimm instead of a 25k, I wonder what's the difference

Ok, so I built this pedal with all the correct components and took my time.  The pedal sounds like a broken speaker, not sure whats wrong.  Can someone help with the troubleshooting?

I hope so, it's my next project

That's some bull shit, the board is faulty?

Q11 and 12 are new 2n5088 and Q13 is a MPSA13.  I'm going to replace the Darlington transistors again.