News:

Forum may be experiencing issues.

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - oldsoul

#1
Build Reports / Re: Glasshole phasor
December 30, 2021, 04:35:12 PM
Curious what did you use for the LDR cover?
#2
Tech Help - Projects Page / Glasshole LDR Cover
December 21, 2021, 05:48:04 PM
I'm building a Glasshole project and though it might fun to use Mil-Max sockets for the LDR LED so I could swap different color LED's. The LED obviously sits a little higher. I'm building a custom enclosure so not concerned about it fitting just wanted some advice for a light shield.
#3
Thanks for helping me get to the bottom of it. It's what I was suspecting as well. I do prefer the tone with the octave engaged as well. Onto making a custom enclosure tomorrow. Giving this as a Christmas gift to my brother. I think he'll enjoy it.


Sent from my iPhone using Tapatalk
#4
Ok I accidentally destroyed one pulling a leg out. So I swapped them both with good tested ones. The tone still feels about the same. Perhaps I'm hearing a low end boost from the lower octave making the non octave switched setting to appear thin.


Sent from my iPad using Tapatalk
#5
Got it. They are GE's from a crystal radio vendor. I pulled one leg off each. They both only conducted in one direction and measured 341 & 388 ohm's respectively.


Sent from my iPad using Tapatalk
#6
Yea perhaps not the best example. Would mismatched 1n34a's cause the tone to drop bass?


Sent from my iPad using Tapatalk
#7
So I touched up solder joints and re-checked voltages which all seem good. Still noticing a thinner tone unless the octave switch is engaged. Not sure if this is helpful but just recorded an iPhone video of what I'm hearing. https://www.dropbox.com/s/02jli7zowxfzb3a/IMG_0353.MOV?dl=0

#8
Thanks jimmilee I planned to hit those joints again. You know I actually do not think I checked the diodes with my meter. Probably got lazy after checking the resistors. Can I check them in circuit or do I need to pull them out?


Sent from my iPad using Tapatalk
#9
Tech Help - Projects Page / Retrograde tone sounds thin
November 25, 2021, 12:16:28 PM
Thanks, but how do I do that?
#10
Well they were new caps.


Sent from my iPhone using Tapatalk
#11
The octave switch it temp as its a On-Off-On, so its just pigtailed in. I'm waiting for the On/On to come in the mail.
#12
checked voltages at Q1-Q2-Q3 all seem really close to instructions. Checked for bad solder joints, all seem solid.
#13
Tech Help - Projects Page / Retrograde tone sounds thin
November 24, 2021, 08:17:13 PM
Just finished building a retrograde and noticing the bottom end really disappears until I switch the octave down. Regardless of settings the tone gets very thinned out unless I switch the octave down.
#14
Build Reports / Re: Naughtyfish!!
September 02, 2019, 08:43:23 PM
Solved this with a swap of the Vol pot. I originally had a linear pot as that was what the build called for. I swapped it for a LOG 100K and it feel much better.
#15
Trying to get back to this. Any insight?


Sent from my iPhone using Tapatalk