Messages

Thank you guys. That answered my
question completely. Unfortunately, and I think unrelated, the pedal doesn't work at all. I had to desolder a few things and I lifted some traces on accident, so I used some scrap resistor snips to do some point to point wiring... But I get nothing. Nada. No sound bypassed and when I turn on one of the channels it is noisier than a jet. I used my audio probe and can get signal through at multiple points... I just don't know. Seriously, I will pay someone to check my work, because I don't know what I did wrong. 

Hey! I was wondering if i had this set up right. I'm building an Aristocrat, i have most of the board populated (waiting on two Nichicon Fine Gold caps) and i noticed on some other successful build reports here that my DIP switches looked different than theirs. On the pdf of the Aristocrat v4 layout, as well as the pcb, have screenprinted on them where the DIPs are placed (from left to right) a number 2 and then a number 1 and then in the center of it, a "+". http://i1140.photobucket.com/albums/n578/whattheadam/aristocratboardlayout.jpg

I matched my DIP switches orientation to that, but in order to have it match the 2 on left 1 on right, it is upside down, and resultingly my "on" is down rather than up. It seems backwards to me. http://i1140.photobucket.com/albums/n578/whattheadam/aristocratboard1.jpg

I didn't know there was a positive side to a DIP switch... that's why the + is confusing to me.

Can someone please help? I know it's kind of a silly question...