Messages

Curious if anyone has pulled off this Green Bean -> Neutrino build.  I followed the parts replacement mentioned above, flipped BC550s around backwards (as per build instructions) but am just getting a quiet fizzy guitar sound out of it.  I haven't started the brutal troubleshooting steps but just was curious if anyone has done this build yet... before I go chasing shadows...
cheers
andy

Anyone have a quick and dirty way to make the Sunking true bypass?  I'm loving the effected signal but not the buffered signal.  Pedal is already built and i have a 3PDT switch ready for this mod.
thanks
andy

the 7660SCPA chip solved the problem.
thanks!

andy

so it appears the "SCPA" version of these chips is the way to go.. both the 1044 and the 7660.
i'll check my local electronics shop for these.
could i have a grounding issue?  my ground run is from the AC adapter.  the middle lug on the 3PDT and the middle tab (jack barrel) of the input jack connects to it (no battery option).  the middle lug of 3PDT also runs to the ground on the board.  output jack is grounded via chassis (no connection to ground tab).  output wires shielding grounded back at the negative of AC adapter jack.  (shielded cable added later, no change to squeal.)
thanks!
andy

ok cool thanks.
which MAX1044 do i want?  CSA, CPA, ESA or ESAT?
i want to order a MAX1044 and the 7660SCPA to see which is more quiet.
thanks!
andy

hello all
i just finished the Mad Bean Sunking pedal. It all went pretty well except my pots were wired backwards. genius that i am... 
anyway, it sounds pretty good and as expected except when the effect is engaged there is a faint but audible high pitched squeal present. you can here it when i'm not playing with amp at a reasonable volume. i tried wiggling wires and even replaced the wires from OUT to SWITCH to OUTPUT JACK with shielded mini cable (grounded by the AC adapter jack). nothing helped. it's not 60 cycle hum but something far higher in frequency. dogs would hate it!  charge pump chip is 7660 CPA.
anyone experience this? or from another pedal?
chain: 1989 Fender Strat Plus with Hotrails -> Sunking -> 1948 Gibson GA30. Amp grounded at chassis. AC adapter for Sunking 9.7VDC. The Gibson is the only amp i have around at home right now so cannot test with another quite yet. gotta hit the studio...

thanks for any insight or suggestions,
andy