Messages

replaced both ic s, put on the right power suppy in !!!!DC!!!!
and it is working like a charm!
just got to figure out how to trim the osc and it is all perfect.

THANKS for your nice pedals!

PS maybe you add the info about the ic layout in the manual (bought it from musikding.de)

So, finally I sorted it out.

I dont know why, I did this, it s just too stupid.

I put on a VAC 9 Volt instead of DC.

The loud humming / noise sound is gone, but the small chip TL072 get still hot and i only hear a very quiet signal but no effect of changing sample rate or resolution.

did i fucked it up entirely?

sorry for my english, i am from germany

Okay!
So I now changed it, but the loud noise still exists.
Do you think the IC is broken? Or are they protected against such stupid mistakes?
I could buy a new one in my city...

I see, but how do I know where to find it on the board?
I only have a notch marking...
THANK YOU!

pdf

Here is the schematic...

I could upload a audio record but i cannot check it with a meter.

Hello everyone,

I think I did not install the TL072 in the right way.
So it turns quite hot and I have almost no Audio Signal but a loud noise.
I can change the sound of the noise with the OSC Gate, or with the RES and SAMPLE RATE.

There is a small dot on the chip but not a sign on how to put like on the big LM324.

THANKS!!!!!
Cornelius