Messages

Verrrrry interesting....

Thanks first to everyone who helped...much much appreciated!!!  Those wiring diagrams make sense and I see how to wire it now ( I think... )

OK, so I think I slightly misunderstood the "boost" pot and the "Midrange/Fullrange" Toggle from the reading in the documentation.

So...that 500k boost pot is actually attenuating the signal, and when there is no attentation (0k resistance, boost full up) it is a "full signal" passing through creating the percieved boost?  Is this correct?

And by looking at the schematic it looks like the "Midrange/Fullrange" toggle is effectively in the circuit at all times.  From reading the documentation I was thinking it was only effective when the boost was "engaged."  The documentation says...
"The MID switch lets you choose between full range and midrange in conjunction with the Boost control. You can use either an SPST or SPDT."

Hmmm....well, I am headed out the door to drive to a gig but will check back here after bit.  I will also respond to the question about the enclosure finish when I have a few more minutes to type.

So I'm finally getting around to building up the Mysterioso Jr board I bought a very long time ago.  I read in the PDF that you can put the "Boost" as an external pot and wire it up to a 3DPT switch.  So with that in mind I laid out my box....etc...etc.  However as I'm putting it together I realized I don't know how to wire that up.  Any help?

I know it needs to take the pot in and out of the circuit, and activate the LED labeled "boost"

Thanks!  Below is a pic of the build thus far...

Getting ready to build up my Double Flush board and already have a few LDR's on hand and was wondering if any of them would work in this circuit.  I HAVE a VTL5C2 and a NSL-32.  The schematic calls for VTL5C1.  Any help would be appreciated.  Thanks!