Center pin of the regulator does not go to GND so a different voltage than 9v can be expected on the output pin.
- Welcome to madbeanpedals::forum.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
Tech Help - Projects Page / weener wah
June 12, 2014, 06:39:09 PM
Hi all,
I am trying to build the weener wah etching version. There is a axial 4uf cap on the PCB project and the space on the etch board is for a standard radial electrolytic cap. Question: Can I place a 4.7uF cap, will make any difference in tone or cut-off frequency?
I am trying to build the weener wah etching version. There is a axial 4uf cap on the PCB project and the space on the etch board is for a standard radial electrolytic cap. Question: Can I place a 4.7uF cap, will make any difference in tone or cut-off frequency?
Pages1