Messages

Hello.
Problem solved.
I put an electrolytic capacitor 10MF, pin 3 to ground RATE potentiometer.
regards

I forgot.
The power supply is Marshall 9 vdc 400mA.
We continue with the problem.

Hello again.
I've done the above tests, and still the same.

I have also checked the input is connected to ground when the pedal is off, and correct.

Thanks for your advice !!
The IC I installed is recommended in the instructions, the TL062.
I'll try with 4558.

I'll also look if there are wires that pass near the LFO.

Thanks, and I'll tell you how it has gone.

Hello.
Some time ago I built a super luxe Zero point delay.
Sounds great, but I have a problem.
When I have the pedal off, plays in the background and rhythmically one (tick, tick)
which is caused by the RATE, the modulation part.
When I put the maximum Rate disappears, but at lower speeds can be heard.
How I can remove that noise?
Thank You