If you decide to etch, which I have never done, I would definitely buy one from you. Thanks for the docs and will definitely look into it. Thanks for the reply and the help!
- Welcome to madbeanpedals::forum.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
General Questions / VP Jr buffer wiring.
February 27, 2015, 03:37:22 PM
So I built this buffer http://parasitstudio.weebly.com/stripboard-layouts/amz-buffersplitterto use in my vp jr. I decided to take out the board that was in there and just put new jacks and wire everything from there and this is where i got lost. I dont know how i should wire this to the jacks and the volume pot...Can some one explain it to me. I know there are people who "sell" this type of mod like JHS and T1M but I had extra parts and its cheaper.
#3
Build Reports / Re: Rullywow Queen of Bone
January 13, 2015, 04:22:45 PM
i fried my led also turning it too much? then i turned the other led to see what i did wrong and pfff goes the other led lol. I replaced both and moved the dial back and left it there...not moving it ever again!
#4
Build Reports / Re: Don Draper Delay (Sea Urchin w/ Tap)
May 19, 2014, 01:34:19 PM
Don Draper...favorite show. The pedal looks nice too.
Pages1