Messages

Yes, the fuzz output volume. I've ordered the trim pot, that seems like an easier way to go than trial and error with resistors. Thanks for the help!

Hey, noob here. I have a basic question about builds that are not from this site. I hope I don't get chewed out for this, but after browsing diy forums, this one has so far been the most active and helpful to me.
So here's my progect-
I am trying to install a simple 9v amp http://www.runoffgroove.com/ruby.html
and a distortion effect http://www.diyguitarpedals.com.au/shop/boms/7_Min_Fuzz_Schematic.pdf
inside a cigar box guitar. The idea is to have a simple, travel, jam guitar that you can switch on and plug any speaker or headphones into.
My goal is to make the guitar as simple as possible to play with minimal switches and controls.
I want only a volume pot for the amp and an on/off switch for the fuzz. My thought was that I could put a resistor in place of the fuzz pot at the right level to get the distortion effect at the same volume as the clean tone.
Is this possible??
I have already built the 2 components with some success, I am still trying to work out the cracks and buzzes.