Messages

Hey, look at that! Awesome, thank you so much!

404 not found

I'm actually looking for the chunk chunk pdf, if anyone has a link. I am trying to finish  the one I started years ago.

For some reason, the 16mm pots are not lining up with the rest of my schematic. Same thing with the film caps in the Madbean library. Looked online, no solution. Any suggestions?

Thanks!

Thanks for all of your advice. Should have know the tayda stuff was cheap. The leads on the resistors are very flimsy. 

Thanks again!

Is the tayda TE-CK-6.35-29B pcb mount jack a direct fit where a nuetrik nmj6hcd would go? Couldn't find a data sheet for the tayda and I forgot to add them to my order.
Anyone have experience with them? Any help is much appreciated. Thanks!