bump
- Welcome to madbeanpedals::forum.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
General Questions / Re: First gen Mystickal Unicorn pcb ?'s
May 21, 2010, 06:11:13 PM
What will happen if i wire in an on/on switch instead of a an on/off/on switch? Is there anyway to have it stock and just the other set of clippers w/o the raw unclipped choice?
#3
General Questions / Re: First gen Mystickal Unicorn pcb ?'s
May 21, 2010, 11:42:39 AM
cool. Thanks.
#4
General Questions / Re: First gen Mystickal Unicorn pcb ?'s
May 21, 2010, 04:30:40 AM
on the dual gang gain pot, which set of lugs is "gain 1" and which is "gain 2" when looking at the back of the pot? Thanks.
#5
General Questions / First gen Mystickal Unicorn pcb ?'s
May 19, 2010, 11:42:29 PM
Do I have to populate the portion of the board that was reserved for different clipping options? Do I need to bare wire jumper anything. Please advise. Thanks in advance.
Pages1