Messages

I do see that the ggg diagram that Gledison gratiously supplied has both included but the switch wiring is different that the mangler doc and there are 4 extra grounds on the board in their diagram. Is any of that needed?

So how are both the dc jack and battery snap wired? Everyone has only explain one or the other I believe. Maybe I missed something, but it seems like everyone is saying it can be done but not explaining exactly how.

Sounds like should just lose the dc jack and just use a battery from what your saying. Problem is I already have a big 1/2 hole on the side of my enclosure.

Do I really need a special positive dc jack. I've been searching a lot online and this is the first I've heard that. Also I can't find a single source to purchase one.

That second diagram is exactly what I need except it doesn't include the dc jack. Can anyone explain how to wire the dc jack into that diagram?

I did see that suggestion mad several times but I am including a DC jack in the build. The dc jack is connected to the -9V in the PCB. I really want to use a dc jack and I've already drilled the enclosure to include this. Really what I need is a diagram like the general wiring doc that MadBean provides that is suited to this build. Can anyone help with that?

Hey Gledison. I have the black wire of the snap connected to the ring of the input jack and the red connected to the dc jack.

The 3rd picture that I uploaded shows a pretty good angle. My finger is holding the snap outside of the case.

Thanks for the help.

Anyone have a chance to look at the pictures I uploaded to offer some help?

Thanks for the tips rockhorst. I only had red and yellow wire, ill keep your suggestion in mind for the future. I'm using NKT275 trannies.

Pics
https://www.dropbox.com/s/8qayegaskqcwtpj/2013-11-02%2016.24.17.jpg
https://www.dropbox.com/s/ixaarpkp6j6cl89/2013-11-02%2016.24.12.jpg
https://www.dropbox.com/s/lbbu1k7oyivm0gk/2013-11-02%2016.23.41.jpg

I have made 1 modification from the pics. I have the wire that is connected to the tip of the in jack connected to bottom right lug on the switch. Was connected to the top middle lug.

Mojotone has carbon comp resistors.

+1 mouser, just a little difficult to figure it all out.

I will post a few pictures this evening. Thanks to everyone trying to lend a hand.

Haven't tried the dc jack yet. Planned on running it with a voodoo pp2 when I get around to buying one.

Mad Bean, any chance you could create a complete wiring diagram with a dc jack and led for the mangler? I'm piecing things together and I'm doing something very wrong.

Thanks if possible.

I have the electrolytic capacitors in the correct orientation I believe. Circle pads are neg, square are positive correct?

Can anyone point me in the right direction on how to fix this?