Messages

Not quite.  This doesn't follow the lugs I mentioned in the original post, but it works the same way. 

Thanks.  I may be missing something, do you not count the lugs like this the photo attached?  Just to confirm, the way I drew it out will NOT work, correct?

Thanks for the info, just a very casual builder that builds 1 or 2 pedals every 10 years when the urge hits me 

The bypass switch:
lug 2 - input jack
lug 5 - output jack
lug 3 wired to lug 6
lug 1 switcher lug 2
lug 2 switcher lug 5
lug 8 ground
lug 7 led

Effect switcher: lugs 1 and 4 go to the in/out on effect 1
Effect switcher: lugs 3 and 6 go to the in/out on effect 2
Effect switcher: lug 8 to ground, lug 7 for effect 1 led, lug 9 for effect 2 led.

Just cause I'm a visual person, do I have this laid out correctly?  Thanks again!

The bypass switch:
lug 2 - input jack
lug 5 - output jack
lug 3 wired to lug 6
lug 1 switcher lug 2
lug 2 switcher lug 5
lug 8 ground
lug 7 led

Effect switcher: lugs 1 and 4 go to the in/out on effect 1
Effect switcher: lugs 3 and 6 go to the in/out on effect 2
Effect switcher: lug 8 to ground, lug 7 for effect 1 led, lug 9 for effect 2 led.

Awesome!

Thank you so much!

Maybe I'm not using the right words when I search, but I'm trying to figure out how to do this.

I'd like to take two overdrive circuits and put them in one box. Have a master on/off foot switch and then an A/B switch to go between the two drives. Basically so I can have different gain levels and tones set.

Does anyone have a wiring layout for this?

Thanks in advance!

Wondered about that, but wasn't sure if that would work.  Thanks!

Wanted to put a Sunking and King of Klones in the same box, and wire them to into each other. The SunKing into the KoK.

Does anyone have a layout how I'd wire that?

Thanks!