Messages

Lonesome bump

I'm still having the clipping issue, not sure if its because of the clamp diodes or some resistor value I could change. Any help would be very welcome. 

Hey boys! I just finished up one of the fine Zero Point DD's and everything seems to be working as it should. Trouble is when I plug in my double humbucker tele I get some pretty noticeable clipping on the delay. I was just wondering if this is a common problem, and if so if any of you brains out there found a way to make this guy a little more humbucker friendly.

I can post the guts n all, but I figure this is more likely just due to some component value or whatnot.

Thanks