Messages

I've just used the build doc drill guide.  Make sure you're printing to scale and exact.  Spend a bit of time aligning the template.  Tape it down and use a small bit to drill center holes.  Drill to specified hole size and you're gold.  Tricky part is getting the template taped down but visual is close enough.

It was just a general observation guys. Build was successful.

Got one! Plus a decent drill press. Measured 10x, punched and drilled once. I'm not a CNC machine, I'm bound to not be perfect. Not much room for error with this thing.

...and you think your enclosure drilling game is ON POINT...try a VFE build!

I am so glad I don't do this for a living, I have a feeling my margins would end up in the trash bin.