Messages

Ok thanks.. I'm going to try and bread board it

What do I have to do to make a circuit Positive ground? Simply wire it that way and use a PNP transistor?? This would be for an Alembic Stratobooster.

Hey everyone, I wanted to add a tone control on to a Mark2 Tonebender. I don't want to build the 3 knob sola sound because I like the sound of the Mark2 better.  I was thinking about doing a simple one I found on BeavisAudio and putting it last in the circuit.  Anyone had any experience adding tone stacks to fuzz pedals? Any advice?

I was interested in taking an alembic stratobooster circuit board from GGG and adding a tone filter cap to cut out the low end via a switch. To allow me to toggle between a full stratobooster boost and a treble boost.  I was looking for some advice.. I was thinking to put a .0022 or .0068 cap between the input and the transistor.  I would be switching between no cap and cap.  Does this sound like it would work??

Hey I just built a Jordan Bosstone from GGG and when the attack knob is low it sustains and does this octave thing.  Does anyone know if that's normal??

I would love to hear your results! I was checking that paper out..

I was wondering what people's opinions are on printers. I have been using an epson artisan with Claria ink and it has been horrible.  I tried all the different settings and it just doesn't give good results. Thanks!

Thanks... I'll check that out.

Where do you buy your water slides? What brand? I've been getting mine from pedal parts plus but I saw one brand that claimed it was heat resistant. It said to print a mirror image place it on backwards and wipe off the glue. The one I tried and messed up was only baked at 200 deg.

I have been baking my enamel paints and using water slide decals and finishing them with clear coat enamel.  Has anyone baked on an enamel after putting a decal on the pedal? Will this work ok or will it ruin the decal? Any advise will help.. Thanks