Messages

Thanks Dan!!!!! i'll do it

Appreciate it if you could help me on how I can remove the pop sound so loud when I change my bypass pedal that purpose.

  I need to add some resistance to the switch? Thnaks In Advance

Excellent!!!!!! i like the glossy finish!!!!!!!! Congratulations  the envirotex job its and art

Thanks paul and Jacob

The pedal Sounds amazing, first i use the pedal with my les paul and forget the notion of the time for about 1 hour im very happy with this pedal, then i use the pedal with an active bass, the result sound with this was very low i dont know why i think is for the high impedance, then i use with a passive bass and i was delighted!!!
and the relationship going well. Sorry for the delay to respond but im very busy in my job im chemical engineer.

Next pedals are ThunderChita (Thunderpuss) and a Egotiger (Egodriver)!!!!!!!!!

About the Feline series talk with my wife and she said that can do it!!!!!!!!jejejejejejejejejeje

more pictures !!!!!

  This is my second build take me a lot of time to finish it!!!!!  But here is now , about the paint my wife ask me  if she can paint my plastic white enclosure, and she creates a zebra pedal and i like so much the design.

   In the las part of the wiring job i had a little accident, i burn a little bit the plastic enclosure .

    I hope you enjoy my second master piece IMHO!!! jejejejejeje 

THANKS MADBEAN!!!!!!!!!!

  Hi, someone could explain me the shipping rates post it on the projects page.

my question is if  i could buy 3 board for the shipping rate of 3.50 or i need buy 2 boards for that shipping rate  and i will buy 5 PCB for the 4.25 shippin rate . thanks in advance

Explain me more !!!!!!!  The mod for 1100ms  is a board with two mn3005 above the another Mn3005 on the main board ?? That is awesome 

The Subs Mode is like the chunk chunk sub modes, you can check the next link http://www.madbeanpedals.com/forum/index.php?topic=3632.0

  Hi, I have a problem with the resistor that goes to the cathode of the LED, I'm using ultra bright LEDs  but when I put the resistance of 4.7 K, as shown in the wiring diagram the LED does not light so bright as when I place it directly with the battery.

my question is necessary to place the resistance and what is the function of this resistance? Thanks in advance

  hey glowsheep thanks¡¡¡¡¡¡¡   I have done, your help has been very good to me. 

Hi My names is Othoniel and im from Mexico. nice to meet you!!!!!!!!!! Great Forum, another Mexican Here?

HI TAGWAP I THINK THE NEXT PDF COULD HELP YOU

hi tagwap i hope this can help ypu!!!!