Did you use 1/8w resistors at all? It looks like maybe a couple on the switch.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Show posts MenuQuote from: pickdropper on May 10, 2014, 08:28:34 PMQuote from: mattlee0037 on May 10, 2014, 08:25:15 PM
Super neat! How'd you later the boards or are they just sitting like that?
I mounted the lower one on the switches below and then I mounted the upper one on acrylic spacers and mounted those to the pots/switches below with double sided tape. The pot was lower, so I needed yet another acrylic spacer to bring it to the height of the toggle switch.
Quote from: Rockhorst on May 03, 2014, 10:20:51 PM
Gorgeous build!
Silly question but...I've seen that metal tube protector on more than one build and would like to use it as well (I've three Valve-e-Tizer boards waiting)...what is it? Where do I go looking for it in (supposedly) the hardware store?
Quote from: hoodoo on May 03, 2014, 02:11:22 AM
Have you thought about putting a new thin layer of enviro over it, wouldn't matter if it was sticky underneath a hard top layer, worth a shot.
Quote from: haveyouseenhim on May 02, 2014, 09:10:03 PMQuote from: BuGG on May 02, 2014, 07:03:55 PM
I vote for a BLMS T-Shirt, same graphic as the sticker!
+1000. I would wear it.