Messages

A bit of slack is handy too if you need to do any troubleshooting! 

Cheers!

Guts are a bit of a mess, most of the offboard wiring could be a lot shorter but I just wanted to get it boxed up

Bangarang's Mutron Phasor II clone.



I've built quite a few kits before but this is my first build (forgetting about my failed Clarinot) on single sided copper etch and my first build where I drilled my own enclosure.

Pretty pleased with how it's turned out

Oh wow! I solder at 400 degrees Celsius is that too hot? Will look into getting a smaller tip

Oh really!?

I was given a nice ERSA soldering station and I'm using this tip which is the smallest I could find that would fit it

https://www.amazon.co.uk/gp/product/B000UX9VMK/ref=oh_aui_detailpage_o01_s01?ie=UTF8&psc=1

Is this not ideal?

Whenever I make a pedal on single-sided copper etch I always seem to get a couple of lifted pads. Is there a better way to repair these than just use jumpers/solder bridges to the next component along?

I've just finished a Mutron Phasor build, is putting hot glue from a glue gun on the solder side of the board an option in order to stop it touching the enclosure?

Sorry about the n00b question but will OSHpark do you a nice double sided board of an etch schematic e.g. if I sent them this