Messages

Wow that's sharp, and a ton of stuff packed into it.  Really nice!

I just finished these three this morning.  A tenebrion reverb with medium brick, Mutron V clone and a clone of a Walrus Audio Mayflower drive.  All sound great.

nice!  funny, clean, what's not to love?

wow, just....wow....nice

sooooo nice, inside and out

thanks everyone.  Cooder, your dog is beautiful.

sweet!  what is that thing next to the toggle switch, some sort of led?

really cool.  I've got to try etching one of these days.  good job

wow, you are clearly a master at this.  everything you make looks so nice and professional

cool, I like the ink job.  never tried those

Just finished this over coffee this morning. This is based on the Bearfoot Dyna Red Distortion.  I added a mid-boost switch that flips between two different cap values in the tone circuit (currently a 100nf and a 470nf).  I wanted to make something that looked "beat up" and this is what I came up with after taking a dremel, files, wire brush and doing a rough cut on the top plate with a jig saw.  Attached the dog tags with paper clips, put screening over the holes and added two red LEDs to light it from the interior when it's turned on.  I think I'll take the knobs off and beat them up a little bit on concrete or something.

really nice.  I love those knobs

clean and really nice looking

I should have said options rather than mods.  I meant that I opted to do the clip, thick , fat options and the buffered/true bypass switching.  I opted for bat41s in d8 and d9 but socketed them.  I love the way it sounds, although the clip,thick and fat options are subtle.

This one is from the tagboard effects layout with the externalized trim pot for the bias.  I honestly only built this one because I had the idea for the graphics and wanted to start doing some vero stuff.  Will probably pass this one on to a friend since I don't need another compressor right now.