Awesome! Where did you get the pcb for the Fonik? I've been looking for a good sequencer pcb that's fairly reasonably priced.
Sent from my iPad using Tapatalk
Sent from my iPad using Tapatalk
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Show posts MenuQuote from: bcalla on December 30, 2013, 12:51:37 AM
If anyone is holding back on the Loophole because 20 seconds isn't long enough, I just put a 90 second chip in mine and it works perfectly.
I originally used the recommended ISD1020AP that Small Bear carries. But a few weeks ago I was placing an order with a Chinese eBay vendor and noticed that they carried the ISD2590P, so I bought one and it works. I'll post a link to the item if anyone is interested.
Quote from: Guitarmageddon on October 05, 2013, 05:41:36 AM
Thanks. I made it up myself, but it's a little like a buffered splitter design by Jack Deville.
There's quite a few out there, including some really simple FET based ones, but I've generally had better results from the opamp designs.
I think I posted the layout in one of my other build reports...
Quote from: Guitarmageddon on October 04, 2013, 08:15:51 PMQuote from: Droogie on October 04, 2013, 04:16:16 PMHere's the DOD280 layout I adapted. I added the blend part myself, but don't have a complete layout drawn, sorry. The bright switch is a 1n cap on the level pot, an idea inspired by Mark Hammer's Ross Compressor mod.
Could you link to the vero layout? I seem to have to build every compressor I come across...