Messages

OK so there's no solder bridge between R21 and R24 and R12 is 470R.

Going to take the voltages tonight.

Does LED2 need to be installed for the circuit to work?

sorry been really busy will try and have a look this week

I'll double check!

well that's what I thought it has to be the chip or the part of the circuit that mixes the delay chip signal in with the dry?

I got them from this German website
http://www.musikding.de/wartung.php

Thanks, I'll measure the IC voltages and get back to you

Finished up my Pork Barrel last night and I'm not getting any effect. When I engage the effect the signal gets slightly brighter but there's no chorus. I've tried adjusting the trimmer to no avail.

Here's some photos of my build, any idea where I should start looking for issues?

Looks great! Is the star a stencil?

This sort of translucent effect? Is it a coloured lacquer?

just measured the resistance on the pot and I'm getting 03.3 ohm at both ends of the sweep on a 20k pot. Definitely something wrong with the pot

can't see any solder bridges, must be a duff pot

cool will have a look for solder bridges and try a new pot

Just finished a Demo Tape Fuzz clone on a board from Jed's Peds and weirdly the gain/trim pot does full gain fully clockwise but also fully anticlockwise with different shades of gain in between. Is this normal?

thanks! not an etch actually, just a sticky label over the top of the sanded enclosure top. Used a layer mask in Photoshop to make the artwork look worn

Just rehoused this, one of my favourite fuzzes! It's a silicone tonebender with control over the transistor bias, voltage and input caps. Able to get a massive range of sounds from heavy fuzz to weird oscillations and gated fuzz