Messages

I have... Thanks for the help.  Would love a link to this specific topic.  Haven't found one.   

it's working just fine, sounds great except the delay has a slight hum, or "hiss" on the repeats... any reason for this? 

has this happened to anybody??? surprised it was from Smallbear, they seem to always send the right thing... guess I'll be checking all values before installing in the future.

finally got around to looking this over and found out that they sent me a bunch of 20K resistors instead of the 10K's...
right?  red, black, black, red, brown, is 20K... SMH...

yes they die out completely... I socketed R24 and tried some different values there. no change.  thanks for the reply MB

I replaced the pot, reflowed all joints.  Maybe a bad IC?... though the ghost switch is working so i assume they're both good?  Lost over here.  I'll stick w my MXR for now. 

i guess theres a slight oscillation... replaced the resistor... still most repeats i can get is about 6-7?? 

thanks in advance... I'm not using a battery.  I should have ordered the mono, but i got of these...
where's the sleeve, tip, ring? 

Am I missing something.  I used BC 549 instead of the BC550's.. the pinouts are same based on my googling.

I've played tons of reverbs as I'm sure we all have, but this thing really shines.  Great character and tone...
Found myself playing for 2 hours with new inspiration I haven't gotten out of a pedal in a while.  so thanks Brian..
Beats the shit out of the stock verb on my DeVille.  An added plus is that with an amp's spring some tone is lost IMO.  This keeps your the connection between fingers, guitar and amp in tact while adding a nice flavor to it.  Cheers...

don't tin when I'm solder into a board.  Only when solder on to pots, switches etc.  I'll give it a go.

to achieve solid connection and neatness? thanks
I aways just bend lead to secure it in place.  there's gotta be a better way.

Green diode lights, can get a bypass signal but no effect and on/off led does not light. 
After a increasing high pitched squeal happens and SUPER loud.  Could this be a bad tl072 chip? 

I figured as much.  Just wanted to make sure... This board calls for 8 of em so just double checking... Thanks

Says the electrolytic caps should be 16 or 25v... I'm having a hard finding the 1uF's in that range.  Gotta ton at 50v... Can I use these?? thx