i finished mine over the weekend. Really digging the pedal, can't wait for the Timelapse. Make sure your power jack doesn't make contact with the enclosure!
- Welcome to madbeanpedals::forum.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
#32
Tech Help - Projects Page / Re: Total Recall Gain 2 trim - volume always low at IC4, two separate builds
February 08, 2016, 06:40:39 PM
My bad yes, Pin 7 on IC4 gives me a very faint signal adjusting Gain1.
#33
Tech Help - Projects Page / Re: Total Recall Gain 2 trim - volume always low at IC4, two separate builds
February 08, 2016, 03:19:08 PM
I'm having a similar issue. I used NOS MN3005's and it sounds fabulous. The thing is working as it should after i calibrated by ear but going by the Doc and using a probe doesn't get me the results when i probe pin7 or pin4 of IC4_B. Pin 4 is very faint and pin 7 gives me nothing. Could someone verify the instructions in the Doc about calibration?