Messages

I searched and couldn't find any info and sorry if this is a stupid question, but how would I wire two leds to one footswitch so that both light up when effect is on? (putting them in eyes of artwork on enclosure)

Thanks!

I'll post photos of the wiring & board tonight in case the answer isn't obvious but I just built a pork barrel and have successfully made 10-12 pedals prior to this one and when I went to test it out it made a weird pulsing / almost heartbeat noise but nothing else. It bypassed fine but when on it kept making the noise.

Anyone have any idea what might be going on?

Edit: this is the MN3007 version