Quote from: brejna on March 30, 2016, 02:30:58 PM
Thanks, whatever you decide I would like to grab pcb.
I should have some extras when I get the Elecrow shipment in. My initial "projected sales" of the pedal are falling a little short
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Show posts MenuQuote from: brejna on March 30, 2016, 02:30:58 PM
Thanks, whatever you decide I would like to grab pcb.
Quote from: brejna on March 22, 2016, 05:51:03 AM
Love your build and video! Will these pcbs be available to us? Btw did you use 1M in the Lead pot position?
Quote from: culturejam on March 04, 2016, 03:30:03 AM
I've never used gerbers to order from OshPark, so I don't know if their CAM file is compatible.
You should generate a new set of gerbers for Seeed, using their CAM file. It's probably fine as is, but it's best to use the fab's CAM when making gerbers.
Quote from: culturejam on March 04, 2016, 02:56:03 AMQuote from: pryde on March 04, 2016, 02:46:22 AM
Indeed no go. The gerber viewer button stays grey-ed out/unclickable even after uploading.
Did you use Seeed's CAM file to generate the gerbers? I just randomly selected a gerber zip I had laying around, but it was made with either Elecrow's or iTead's CAM.
Quote from: culturejam on March 04, 2016, 02:14:13 AM
Nothing shows up until you click the "gerber viewer" button. Then it loads a new tab. (this is after you upload your gerber zip file)