Messages

Oh wow! Thank you so much for your time and patience with me!

Just reading over your post makes me feel completely positive that I am to blame for issues. Those Mosfets are probably blowing up from being soldered in.

I am ordering the parts needed as we speak. I may even order a few PCB's and completely start over. We shall see....I will keep you guys updated!

Austin

Hey Pandadandan!

I am not using sockets for these, I looked around but couldn't find one that would fit the PCB holes. So, I have been using my heat-sink clamp, but like you said, I still might be frying them.

One thing I did try was to take a transistor and hold it to the traces and test that way, but still found the same results....I will post some pics in a bit.

What sockets do you recommend?

Thanks!

Hey Brian! I haven't spoken with you since I bought several PCBs in November, but have had a hell of a time getting these things to work. (It is most likely me, Sorry!)

I wired them up (Version 2.5) and my wet signal bottoms out compared to the dry signal even though I can faintly hear the crackle. I have replaced countless transistors and tried all the different boards to still no avail. 

Any ideas?

Thanks!

Austin from Denton.