Messages

If you liike good warm octave fuzz with some serious sustain, this is the one.

I actually had thus happen on my test rig then noticed my sag knob was on a little, maybe 7-8volts, and my Klone was squealing like a banshee. Once I put it back to 9 volts everything was fine

So long answer, power supply?

I've tried several methods and so far this has been the most organized and easiest to use. Capri Sun FTW !!!

Comfort who?

:-)

Amazing,,,

this is my favorite comment on the youtube video

"The guitar tab for this song are available from..."    right....

Just what is the tab symbol for retuning on the fly

I'm in. Thanks Brian :-)

That my friend is ...uh..... Classic 

Thanks for the info Brian.  I saw in the build docs that the led cipping was optional but was unsure on which switch position went where

If I want to use default clipper in the ego driver so I just jumper holes 1 and 2 on the clip switch and omit the D4 and D5 LEDs ?

.....What temp are you guys running at for prefabbed boards?

I run around 720.  From the time you turn it on the Hakko can get to that temp in about 10 seconds.  

Entire thread on the subject here http://www.madbeanpedals.com/forum/index.php?topic=5702.0

I started with a Weller and went through tips a little faster than expected. I upgraded to a Hakko FX-888 and love it.  Temp control, long lasting tip, built in brass cleaner.

Picked mine up off of ebay with a couple of tips for well below your budget.

Kingslayer

Well done Bob.  However, just an FYI Larrivee has been using streaked ( or natural ) ebony for years.  I have and do own both.  Looks good to me either way

I knew it was something like that, but could not remember it exactly  ( not that much of a geek ) so it was Wiki to the rescue. 

Nice, that is the correct answer (of course).

Did you know that or google it?

Jacob

YT-1300

According to the Owners Workshop Manual